Hi, I am having trouble with the office booklet finisher FS608 on OceCS240 (Bizhub 450?)
The staples aren't going through the pages, even just two sheets, and they fold up and cause skewing/jamming on the exit.
I cannot find anything physically wrong with the stapler units with a visual inspection, and before I dismantle them entirely I wanted to seek advice here
(It's not that I am lazy, I have taken the covers, and some motors, guides and so on apart to get a good view of the stapler units from all sides, but I cannot find anything. I was expecting to find a jammed staple in there)
The staples aren't going through the pages, even just two sheets, and they fold up and cause skewing/jamming on the exit.
I cannot find anything physically wrong with the stapler units with a visual inspection, and before I dismantle them entirely I wanted to seek advice here
(It's not that I am lazy, I have taken the covers, and some motors, guides and so on apart to get a good view of the stapler units from all sides, but I cannot find anything. I was expecting to find a jammed staple in there)
Comment