PDA

View Full Version : Corner/Booklet Stapler FS608


Custom Search


Setright
06-11-2009, 07:18 AM
Hi, I am having trouble with the office booklet finisher FS608 on OceCS240 (Bizhub 450?)

The staples aren't going through the pages, even just two sheets, and they fold up and cause skewing/jamming on the exit.

I cannot find anything physically wrong with the stapler units with a visual inspection, and before I dismantle them entirely I wanted to seek advice here :D


(It's not that I am lazy, I have taken the covers, and some motors, guides and so on apart to get a good view of the stapler units from all sides, but I cannot find anything. I was expecting to find a jammed staple in there)

strider5555
06-11-2009, 11:26 PM
What has most likely happened is that someone has moved the stapler units out of position by hand, perhaps to load staples or such. The consequences of doing this has misaligned the stapler head and the clincher unit. You will have to realign them before you can staple normally.

Setright
06-12-2009, 05:57 AM
Allrighty then! I will try to do that :D

Hopefully the service "installation" manual covers it in detail.

Custom Search