Hansoon
06-13-2009, 01:52 PM
Di-3510, splash screen freezes with NC-4
Di-3510 with Pi-3502e controller SU-2 scanunit and NC-4 interface.
History:
Got this account from another company. Have no experience with these Minolta series. Machine was working well except that the machine wasn't responding to the usual tech code 00000000. Perhaps someone entered an different unknown code so I performed a BRAM clear by crossing the middle and right jumper on the CF-Card board. From this moment the machine works only when the NC-4 interface is left out of the machine. As soon as the NC-4 is installed the splash screen freezes up and the machine doesn't continue to boot. Without NC-4 all functions well. Tried another NC-4 with the same results. What happened? Does it need a special set up now or did I shot something?
Hans
Di-3510 with Pi-3502e controller SU-2 scanunit and NC-4 interface.
History:
Got this account from another company. Have no experience with these Minolta series. Machine was working well except that the machine wasn't responding to the usual tech code 00000000. Perhaps someone entered an different unknown code so I performed a BRAM clear by crossing the middle and right jumper on the CF-Card board. From this moment the machine works only when the NC-4 interface is left out of the machine. As soon as the NC-4 is installed the splash screen freezes up and the machine doesn't continue to boot. Without NC-4 all functions well. Tried another NC-4 with the same results. What happened? Does it need a special set up now or did I shot something?
Hans