Fuser temperature at Minolta Bizhub C500 Pro

[robizhub]

Please tell me how to lower the temperature in the fuser of Minolta Bizhub C500 Pro.
Thanks!:)

[random]

use a lighter paper weight

[robizhub]

I use 90g coated paper ( and the broblem aperar at the second side of the print - exfoliate paper) and if I lower the weight I must use normal paper.
so I will try.
Thanks:D

[KM Dude]

Fuser temp is set using 25 mode softswitches, it should be listed in the service manual.

[lucky13]

is your paper blistering (bubbling) then you need to use good quality coated laser paper made for copiers .press paper will not work

[mrwho]

This is one of the big problems the 8050/C500 have that was solved with the arrival of the C6500. More than one customer I used to visit swapped their 8050/C500 for a C6500 and are still happily using them.

[robizhub]

Problem solved!
Tahnks to KM Dude :"Fuser temp is set using 25 mode softswitches, it should be listed in the service manual." I have dowgrade the temperature with 10 degree. And all is ok!
:)

[Albert]

Problem solved!
Tahnks to KM Dude :"Fuser temp is set using 25 mode softswitches, it should be listed in the service manual." I have dowgrade the temperature with 10 degree. And all is ok!
:)

I have the same problem but i dont know what soft-switches to adjust. Can you tell me please i would like to lower my fuser temperature to 10 degrees. Thank you

[RRodgers]

I have the same problem but i dont know what soft-switches to adjust. Can you tell me please i would like to lower my fuser temperature to 10 degrees. Thank you

As stated above, its in the manual.

[Albert]

In what page number would i find it? thnks

[mrwho]

Page 1-17 (page 49 on my PDF). Check item *13.

[Albert]

Thank you it fixed my problem by lowering the teperature by 10 degrees