langelot
07-07-2009, 05:18 PM
Hi guys and gals (if any),
I'm having the following code with a Konica Minolta Di-3510.
COBAO when the machine is turned on. It goes through a few motions of bringing everything to home position, ect. and then pops the code.
The manual says the following - Elevator Motor Ascent/Descent Drive Failure - which I believe has to do with the large capacity tray/cassete.
The problem though is that this machine does not have an LCT/LCC option, only a regular storage compartment in the drawer base where the LCT/LCC would be.
I suspect either dip-switches, corrupt firmware, or bad board -
Any ideas would be highly appreciated.
Thanks
I'm having the following code with a Konica Minolta Di-3510.
COBAO when the machine is turned on. It goes through a few motions of bringing everything to home position, ect. and then pops the code.
The manual says the following - Elevator Motor Ascent/Descent Drive Failure - which I believe has to do with the large capacity tray/cassete.
The problem though is that this machine does not have an LCT/LCC option, only a regular storage compartment in the drawer base where the LCT/LCC would be.
I suspect either dip-switches, corrupt firmware, or bad board -
Any ideas would be highly appreciated.
Thanks