PDA

View Full Version : HP LASERJET 9850MFP FIERY RIP with Minolta Bizhub pro C500


Custom Search


21043
07-08-2009, 09:38 PM
Hello!

can i plug HP LASERJET 9850MFP FIERY RIP (on photo) to Minolta Bizhub pro C500?

i have another CF5001 with it's own rip, and this rip looks like 9850MFP FIERY RIP, and as i know 9850MFP it is re-branded C500 (8050, C500...).

regards,
Andrey.

http://i.ebayimg.com/07/%21BVyDWIwB2k%7E$%28KGrHgoH-D0EjlLlvkV2BKURM6jzLQ%7E%7E_1.JPG

pepper38_cnd
07-08-2009, 11:10 PM
That is a good question! Can you get a config page out of each of them while connected to their intended product and compare them? This is something I would be interested in knowing as well.

21043
07-09-2009, 08:21 AM
i can get it only from my fiery S300 (with Minolta CF5001).

i plan to buy C500 without RIp and buy 9850MFP FIERY RIP for it - so i cant get this page from 9850MFP FIERY RIP.

mrwho
07-09-2009, 10:08 AM
Unless someone that already tried it replies here, I guess you'll only know when you try it. It's possible that it works without changes, or even if you try to flash the IP-901 firmware on it, but it's also possible that the hardware is keyed so that it will only work on its own machine.

mrwho
07-09-2009, 10:10 AM
On a side note, I once had to use a Minolta Fiery on a Konica machine (the pi7200 of the Minolta version of the Konica 7272) and the only way to go was to flash the Konica 7272 with the Minolta firmware.

21043
07-09-2009, 09:37 PM
i write to Fiery tech support - they actually don't know, will it work or not :-(

mrwho
07-09-2009, 10:10 PM
i write to Fiery tech support - they actually don't know, will it work or not :-(

Can't say I'm the little bit surprised. They make good products - but the tech support is flaky at best.

Custom Search