ravikumarj
08-13-2009, 12:17 PM
Copier symptom in the panel " Now warming up . Ready to scan":confused:
Heater is getting on and the temperature attaining ready,
for the benefit of doubt interchanged with with good working fusing unit.
But symptom remains the same.
The copier green button shows ready. and ready for scanning, after scanning completes no print is taken place.
Cleared all the job memmory.
Still shows "NOW WARMING UP."
Any reset procedure??
advance thanks for tecnical help.
RAVI,
Heater is getting on and the temperature attaining ready,
for the benefit of doubt interchanged with with good working fusing unit.
But symptom remains the same.
The copier green button shows ready. and ready for scanning, after scanning completes no print is taken place.
Cleared all the job memmory.
Still shows "NOW WARMING UP."
Any reset procedure??
advance thanks for tecnical help.
RAVI,