View Full Version : Konica 7145 F51-2
RookieTech
08-24-2009, 11:04 PM
Hey guys I have a Konica 7145 with a F51-2 error code, fuser motor error. Anyone have this part number available?
Thanks
copytechman
08-24-2009, 11:18 PM
Better make sure it's the motor (u can swap with other motors w/same pn# in this machine to test!) Cuz sometimes its not... often it is a control board icp failure.. repaired a few of those! :rolleyes:
Pn# is printed right on the motor
Regards!
A!
mrwho
08-25-2009, 08:41 AM
DESCRIPTION: F51-02. The fixing motor M11, will not turn in diagnostics. CAUSE: Loss of 24VDC to the Fixing drive motor.
SOLUTION: Replace the PRCB (p/n 40LA-9029).
Try this, could be that the motor is OK. Check the ICPS on the PRCB before ordering a new one, as copytechman said.
RookieTech
08-25-2009, 07:49 PM
DESCRIPTION: F51-02. The fixing motor M11, will not turn in diagnostics. CAUSE: Loss of 24VDC to the Fixing drive motor.
SOLUTION: Replace the PRCB (p/n 40LA-9029).
Try this, could be that the motor is OK. Check the ICPS on the PRCB before ordering a new one, as copytechman said.
From a previous post, it was advised to replace the Corona unit in conjunction with the main board. Does this seem logical, or will the main board correct the problem?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.