copycommerce
09-01-2009, 11:21 AM
Hello ,
We are servicing a KM C450.
The pressure roller was teared so we replaced it with a new one( they don't sell it,but we got one from an old machine).However there is a problem,when we turn the machine on and on state confirm page the temperature of the fuser belt and pressure roller is constantly lowering.And when reach 130C the 34XX code appears.We have a couple of old fusers for this machine and we was replacing thermistors,therm fuse,heat lamp,the belt...And still the same thing.We checked the connectors on the boards and they seem fine.
Is there some SW switch to be turned on/off or any other solution for our problem?
We are servicing a KM C450.
The pressure roller was teared so we replaced it with a new one( they don't sell it,but we got one from an old machine).However there is a problem,when we turn the machine on and on state confirm page the temperature of the fuser belt and pressure roller is constantly lowering.And when reach 130C the 34XX code appears.We have a couple of old fusers for this machine and we was replacing thermistors,therm fuse,heat lamp,the belt...And still the same thing.We checked the connectors on the boards and they seem fine.
Is there some SW switch to be turned on/off or any other solution for our problem?