PDA

View Full Version : BizHub FS 606 saddle stitch skew


Custom Search


Desert Rat
09-09-2009, 04:15 AM
:(
I ran into this on an install today. But the customer noticed, the corners
don't match when folded and/or stapled, during saddlestitching or just
folding.
I cleaned the rollers with a damp rag. I could not see an obvious
adjustment for the gate that holds the paper for saddle stapling.
I adjusted the fold and fold and staple adjust in 36 mode, no luck.
I did not have a lot of time to spend on this today and will go back
tomorrow, time permitting.
Any pointers before I go? I have not had the opportunity to work on
a saddle stitcher fold problem before on any model. Meanwhile I will read
through the book.

Thanks for any help

DR

Setright
09-09-2009, 09:43 AM
Most of the folder/staplers do have a mechanical adjustment for the backstop.

Is this a "floor" model, with a pull-out fold/staple unit?

If yes, pull the unit out on the rails, and flip down the narrow metal plate with a green plastic label. You should be able to see two millimeter scales. Loosen the screws and move the backstop to correct the skew.

Desert Rat
09-09-2009, 01:55 PM
:)
Setright,
Yes it is a floor model. And I remember seeing that flap you mentioned.
I may get a chance to get back there today. I will check it out.

Thank you very much

DR

Desert Rat
11-09-2009, 12:59 PM
:o Setright, sorry to so long in getting back to this, but I did want to
thank you for the right info. I was able to go back and make the
adjustment. This corrected the problem.

Thanks again

Dr

Custom Search