PDA

View Full Version : Question about changing developer on Bizhub 163


Custom Search


MihaiGSM
09-09-2009, 04:17 PM
Hy guys! Today i changed the developer and drum on bizhub 163 because it showed on display "MaintenaceCall2". Everything fine, but after changing these, i did ATDC autoadjust with toner bottle inside, by mistake. The value of ATDC after the process finished was 143, i turned off and then on the copier, but the message "Maintenace call2" didn't disapear. To clear the message on the screen a did a reset on service menu.
The copier work fine, the image on the paper is very good, but the question is: it will work again fine next 60.000 copies/prints? Thanks in advance!

harry2007
09-09-2009, 07:33 PM
of course!...why not?the value 143 it's OK. it's no other reason for your concern.

perdana
09-10-2009, 05:13 AM
You need to clear the Drum counter.

bechir00011
08-16-2010, 01:32 PM
You need to clear the Drum counter.
how can i clear thr drum and developer counters

mrwho
08-16-2010, 04:27 PM
If it's the same as the 162, you need to clear the "Supplies Life Counter".

Custom Search