Scijohn23
09-17-2009, 09:37 PM
I am Working on a Konica/Minolta CF8050 with an ip 901. The machine runs fine, but the print controller is not responding. It stays on "System booting" but never boots. I power cycled machine and ran configuration, and attempted to clear the server, also ran the diagnostics and passed. The machine controller says the clear server is not available and then goes back to initial configuration mode and continues to try to boot the controller. Waited an hour and the controller is still not booting. Is there a manual reset for this controller, i noticed two dip switches located by the RJ-45 conector. Please help me,,Thanks in advance.