emujo
11-12-2009, 06:52 PM
Brand new C552 out of the box. Ver 57 on the main body, ver 25 on FS. Will intermittantly throw a C-1145 (End Stopper motor malfunction). When the code pops, I can see and hear the end motor trying to get the stoppers into home postion, but just a lot of drive train noise. Cycle power and everything initilaizes normally. I can sit with customer and run single/double stapled sets with no issues. 1-2 hours after I leave...same code. Customer says they aren't even using staple feature when code pops. FS has a saddle stitcher and hole punch and these are running with no issues. Any ideas? Emujo