View Full Version : Konica 7272 sc 23-04
Naveed Shahid
12-07-2009, 07:22 PM
Hello Every One
I am facing a problem sc 23-04 i changed already pcl but cant solve problem can any one have a idea
thanks in advance
Measure the ICP(small black IC)fuses on printercontrol-board
i belive one of them are faulty. just soldier an normal glass fuse over the ICP
check the servicemanual for the current
Naveed Shahid
12-08-2009, 06:45 PM
dear leo
i already open th printer control board but i can't found icp or fuses co can u give a fever confirm me ic name or fuse name i reaaly appciate u
thanks
Measure the ICP(small black IC)fuses on printercontrol-board
i belive one of them are faulty. just soldier an normal glass fuse over the ICP
check the servicemanual for the current
you can find 3 of them in lower right corner(see att. picture) as an example.
there is a lot of them over the whole card.
PCL is connected to with connector 206 on top of the card, pin 17 and 18, so you can follow the "print-lines" if you have eyes.:)
Naveed Shahid
12-10-2009, 09:55 AM
thanks for great support i will fininshed problem soon
thanks once again
you can find 3 of them in lower right corner(see att. picture) as an example.
there is a lot of them over the whole card.
PCL is connected to with connector 206 on top of the card, pin 17 and 18, so you can follow the "print-lines" if you have eyes.:)
chand
12-22-2011, 06:47 PM
thanks for great support i will fininshed problem soon
thanks once again
hi
did you solve the problem???
Diego Silva, Great player:cool:
chand
02-03-2012, 04:02 PM
no problem of any board...i solve this problem easily..only hardware problem
contact me chand226@gmail.com
chand
02-03-2012, 04:03 PM
you can find 3 of them in lower right corner(see att. picture) as an example.
there is a lot of them over the whole card.
PCL is connected to with connector 206 on top of the card, pin 17 and 18, so you can follow the "print-lines" if you have eyes.:)
no problem of any board
rhalif
07-25-2012, 05:03 AM
I have the same error sc 23-04 with dialta 5510, I tried to change the pcl but it didnt work, I checked also the 3 icp, they all look good, anyone can help me with this ?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.