View Full Version : Need system to IP-511 Type A
lordqpa
01-13-2010, 04:31 PM
I need system for IP-511 Type A e.g. 6.3.0 or higher. On Europe infohub are only upgrades. Hard disk is damaged. DOS starts. Command d:recovery not works. I need information about partitioning hdd and transffering system to disk.
kmcopier
01-13-2010, 08:57 PM
I need system for IP-511 Type A e.g. 6.3.0 or higher. On Europe infohub are only upgrades. Hard disk is damaged. DOS starts. Command d:recovery not works. I need information about partitioning hdd and transffering system to disk.
send me a PM
it's available on infohub!!
Gr Kmcopier
TheOwl
01-13-2010, 09:50 PM
If you have an IP-511 A that is currently working, then you can remove the HDD from the controller and then clone it.
We use Acronis True Imaging to create and restore images without a problem. Konica Minolta AUS even recommended this a while ago.
Using this method, you can save alot of time.
Stirton.M
01-13-2010, 11:55 PM
If you have an IP-511 A that is currently working, then you can remove the HDD from the controller and then clone it.
We use Acronis True Imaging to create and restore images without a problem. Konica Minolta AUS even recommended this a while ago.
Using this method, you can save alot of time.
Acronis is da bomb!
Solves the problem quickly...far far more quickly than simply trying to push system through a parallel port, or network port for that matter.
RRodgers
01-14-2010, 02:32 AM
Good stuff!
lordqpa
01-14-2010, 07:54 PM
send me a PM
it's available on infohub!!
Gr Kmcopier
I've been looking for it on Infohub without success :(
Below are links to screenshots from Infohub:
http://en.fotoalbum.eu/images/7432/408667/00000001.jpg
http://en.fotoalbum.eu/images/7432/408667/00000002.jpg
Can U send me FW on PM.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.