archstructure
03-08-2010, 06:33 PM
Hello! I have a fiery controller on a minolta that diagnoses itself as good, but seems to have a corrupt boot or system file on it.
I am working to find a way to simulate a ECP parallel port and find the proper firmware to put on the Fiery controller. If anyone is well versed in this I have seen a couple of forum listings that talk about the subject, but not as to where to find the system.efi file or if there is a simpler way to begin the install process onto the drive, like remove it and make it a slave. Thank you!
I am working to find a way to simulate a ECP parallel port and find the proper firmware to put on the Fiery controller. If anyone is well versed in this I have seen a couple of forum listings that talk about the subject, but not as to where to find the system.efi file or if there is a simpler way to begin the install process onto the drive, like remove it and make it a slave. Thank you!