If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Konica Minolta Bizhub C-353 Error Code C-3821 HELP PLEASE!!!!
Turn off main power switch (behind front door). Hold the utility/counter key down and turn on main power switch at the same time. Trouble reset will appear on the screen. Touch trouble reset and OK should appear. Turn main power off and on. This will reset the fault. If a electrical glitch (power outage) caused the problem, you should be ok. It may need the fuser replaced if it comes back.
Thanks, I will be trying this today. Please read my next question and let me know.
Originally posted by rocky246
Turn off main power switch (behind front door). Hold the utility/counter key down and turn on main power switch at the same time. Trouble reset will appear on the screen. Touch trouble reset and OK should appear. Turn main power off and on. This will reset the fault. If a electrical glitch (power outage) caused the problem, you should be ok. It may need the fuser replaced if it comes back.
I replaced the router in my network and I think this is what caused the problem. The router was not correctly setup by the VoIP that sent it to me and the IP address for the Konica was not correct. Could this have caused this issue? Once I get into the office I'm going run through your instructions. I will let you know what happens. Again, thanks for your help.
It has nothing to do with the router on your network. Fusing abnormally low temperature detection / The heating roller thermistor continues to detect a temperature lower than a predetermined one for a predetermined period of time.
Basically, if in the room was too cold, the copier cannot get to the proper temperature in the specified period of time. If it is not a hardware issue, a software reset, as explained above, will solve the issue.
Comment