View Full Version : C451 jamming half fold in fuser
got a C451 that half folds paper into the fuser with complete image on paper
Spidula
05-04-2010, 08:53 PM
Congratulations
Spidula
05-04-2010, 08:58 PM
Sorry...just kidding
What Jam codes are you getting with it. Is it doing Duplex or single sided. Is the image fused on the paper or does it not get through the fuser at all?
Cheers
Spid
lucky13
05-04-2010, 09:46 PM
i have had this a meny of times 1st check the 5 pick off fingers on the front of transfer belt unit if any one finger is flipped in it catches the paper,then replace 2nd image transfer roller, then check the sync roller cleaning unit check the thin metal ground tab near the release tab for that unit clean off the built up grease and make sure there is no gap between the metal tab and brass bushing . bend tab if you have to. good luck
250,000 copies on it
where is the sync roller cleaning unit?
lucky13
05-05-2010, 02:46 AM
here you go
Spidula
05-05-2010, 05:37 PM
Yeh. I've had those claws flip back.
Its worth giving the registration roller (sync roller) a clean too. Use WD40 and a clean cloth or, if you have it, some rubber cleaner. Rub it till the roller is dry and has a better grip. Hope this helps.
Spid
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.