copydude
05-25-2010, 03:36 AM
:mad: Help... I have a C5500pro with the Fiery x3eTY2
Server type
N103rccs(65C-KM)
Until this morning all has been fine... I tried to print and I got faults, but I was talking to the server..
Using Command WorkStation I told the server to reboot..
It has not posted since.. I can no longer connect to the server..
I manually rebooted th fiery and the copier.. It is also not communicating with the copier
the LED display
goes to 75 freezes for a few (30ish) seconds then two more numbers.. until 96 at which time it displays FF (fault?)
I have removed it. and it wasn't too dusty, Took the cover off, all fans are functioning , hard drive is spinning, took off the vga port cover and the US covers, connected a key board , monitor and a mouse.. IT looks like the mother board is all good, loads stc.. starts windows xp .. that is where it crashes.. just starts loading and it hits the FF code.. blank screen... even tried to boot in VGA mode...
went into set-up not alot there,, didn't change anything.. there was a mod to load with default.. didn't choose that.. just escaped no changes...
this looks like the OS is not starting..
how would I deal with this?
slave it on my computer and ghost it?
connect a Sata disc drive and try to repair windows ?
try it the same on my computer .. as a primary and try a repair?
also, I see a ethernet plug on my copier, does this mean that is has a built in processor also? \
If so how do I communicate with it..
(sory for the repost.. but I am dead.. also new possible owner in the mornign.. I NEED thsi up)
Server type
N103rccs(65C-KM)
Until this morning all has been fine... I tried to print and I got faults, but I was talking to the server..
Using Command WorkStation I told the server to reboot..
It has not posted since.. I can no longer connect to the server..
I manually rebooted th fiery and the copier.. It is also not communicating with the copier
the LED display
goes to 75 freezes for a few (30ish) seconds then two more numbers.. until 96 at which time it displays FF (fault?)
I have removed it. and it wasn't too dusty, Took the cover off, all fans are functioning , hard drive is spinning, took off the vga port cover and the US covers, connected a key board , monitor and a mouse.. IT looks like the mother board is all good, loads stc.. starts windows xp .. that is where it crashes.. just starts loading and it hits the FF code.. blank screen... even tried to boot in VGA mode...
went into set-up not alot there,, didn't change anything.. there was a mod to load with default.. didn't choose that.. just escaped no changes...
this looks like the OS is not starting..
how would I deal with this?
slave it on my computer and ghost it?
connect a Sata disc drive and try to repair windows ?
try it the same on my computer .. as a primary and try a repair?
also, I see a ethernet plug on my copier, does this mean that is has a built in processor also? \
If so how do I communicate with it..
(sory for the repost.. but I am dead.. also new possible owner in the mornign.. I NEED thsi up)