Bizhub 600 w/ FS-504 Finisher

[Brischaffer]

Hi everyone,

I'm working on a Bizhub 600 w/ a FS-504 Finisher. I keep getting a J-7229 and it tells me to open the finisher and clear the jam. The only thing is that the job is already complete and there is no paper in the finisher to clear. It only does it out of Tray 1 (bottom tray). The top tray feeds fine. I blew out all the sensors cut wire ties and checked all the sensors. I have no clue what is causing this to happen. Any help would be greatly appriciated.

Thanks in advance,

Brian:mad:

[racosta]

Check the wires rite at the exit sensor connection. Sometimes it looks fine but the wires are cut.