View Full Version : Error Code F28-3 on KM 7145
I've got an F28-3 error on a KM7145 and I can't seem to get my head around this.
btw changed developer recently
Thanks
Jett
Albonline
06-09-2010, 02:32 PM
try replaceing the T/S corona, also look at the T/S transfer block on the door this unit is known to eat these parts up.
copytechman
06-09-2010, 03:22 PM
From da book:
F28-3 Separation lightning abnormality
When the EM signal (separate_em) is detected 3 times at the specified intervals, this phenomenon occurs 5 times in 1 job. The main body stops immediately, and the RL1 (Main) turn OFF.
Separation corona
HV (High voltage power)
CB (Main body control board)
Yup, go with what the prior poster said, either the block and insulators on the door or the trans sep unit itself. Been there, done that!
Regards!
A.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.