siradlib
07-21-2010, 08:30 AM
Hi there,
as written in the subject: We have a Bizhub C450 with Fiery (IC-402). There´s also installed a Finisher FS 603. That finisher should be able to hole-punch, staple and folding. This works well with jobs that are send to the Fiery from a computer, and of course it also works when you only use the C450´s copier functions.
However, if you re-send a job from Command Workstation (version 4) you can not choose the option "fold and staple" because Command Workstation insists that there is no finisher installed at all. :confused:
Is there a setting within Command Workstation or the Fiery setup that I´m missing?
as written in the subject: We have a Bizhub C450 with Fiery (IC-402). There´s also installed a Finisher FS 603. That finisher should be able to hole-punch, staple and folding. This works well with jobs that are send to the Fiery from a computer, and of course it also works when you only use the C450´s copier functions.
However, if you re-send a job from Command Workstation (version 4) you can not choose the option "fold and staple" because Command Workstation insists that there is no finisher installed at all. :confused:
Is there a setting within Command Workstation or the Fiery setup that I´m missing?