PDA

View Full Version : bizhub 200/250/350 jamming drawer 1 only


Custom Search


acsolutions
09-21-2010, 01:21 AM
Hello, I'm having an issue with a bh 250 and a 350 same problem, I have replaced the feed assembly, drawer and drive clutch assembly. the problem is it jams right out of the drawer, The paper gets about an inch out of the drawer then jams. you can see the paper when you drop the right cover, the leading edge of the paper is visible. once in awhile the paper will pass through the machine and will be delivered skewed or wrinkled . I tried two different USED feed assemblies with the same results.

Thanks.

fixthecopier
09-21-2010, 10:42 AM
Behind the feed assembly is the drive section that runs it. You need to change the clutch in it.

acsolutions
09-21-2010, 04:52 PM
thamks, I replaced the clutch assembly also!

fixthecopier
09-21-2010, 10:35 PM
I did one this summer, where I changed everything you did, and it still jammed. Seems I pinched a wire putting the bypass back on.

KM7155
09-23-2010, 12:09 PM
is the drum scratch? try to change the drum and the starter unit.

fixthecopier
09-23-2010, 12:52 PM
is the drum scratch? try to change the drum and the starter unit.


What the hell does that have to do with jamming from tray 1?????

fixthecopier
09-23-2010, 12:55 PM
If you do not have a pinched wire, check your photo cells, sounds like one may have failed.

KM7155
09-23-2010, 01:01 PM
if the drum scratch, it will short to the magnetic roller at the starter unit, then will cause the machine to stop.
no harm to try this method if the drum already scratch right?

reydl27
09-23-2010, 10:34 PM
If the drive unit clutch did not fix the problem then replace the 2 small white clutches in the paper feed unit.

Also, make sure the tray is not cracked

acsolutions
10-06-2010, 06:24 AM
Thanks everybody for all your support. I found the problem it was kind of stupid. there is a mylar that sits at the base of the right door where the paper exits tray 1. the reg. /transfer roller unit was sitting right on top of the mylar. The mylar was folded like it belonged in that position. I placed the mylar on top of the guide to the to the reg. roller and it started to function properly.

Downunder
10-07-2010, 10:01 AM
Congratulations acsolutions to acknowledging situation. Just a reminder to us all to keep it simple.

Custom Search