PDA

View Full Version : Konica 7075 SC23-03


Custom Search


arcdigi
10-15-2010, 05:16 PM
How do I clear this out of the computer....it won't even try and come up now. I'm assuming its in 25 start area, but know where to go from there.

Thank you

Alex
10-15-2010, 09:09 PM
SC23-03 during copy mode. DESCRIPTION: SOLUTION ID: 111,778
SOLUTION: CAUSE: M14 (blade) trouble detection signal (excessive current) is detected.
SOLUTION: Ensure that PS30 (blade position) is attached to the cleaning unit. This can become unattached
and fall into the gears that drive the blades. If damaged or failed, replace PS30 (p/n 08AA85510).
USAGE: 1

arcdigi
10-15-2010, 09:21 PM
Did that replaced the blade and the main drive motor seems to be working...does not come up without the error...I don't know where to clear it out from..... last error I got for the warming up had to go into 25 and 3 and 3 and click off and then restart..is there something like this for this error

mrwho
10-15-2010, 10:02 PM
Did you replace the blade or the cleaning unit's motor? That motor seems to be the culprit, or else something else jamming it.

If the problem persists even with another cleaning unit, then I'd search for some blown up ICP on the PRCB (board right in the middle at the back of the machine).

arcdigi
10-15-2010, 10:13 PM
have extra mahines and have tried to replace everything on the back...power on and immediaely goes to the error ..doesn't even try to go to anything'

mrwho
10-15-2010, 11:15 PM
have extra mahines and have tried to replace everything on the back...power on and immediaely goes to the error ..doesn't even try to go to anything'

But did you replace the entire cleaning unit with a working one?

If so, check your wiring.

Custom Search