View Full Version : bizhub 350 scanning using glass
beano
11-11-2010, 12:35 PM
we had a tech out to service the copier now we found out after he left we can't scan using the glass but we can using adf
BIG PAPA
11-11-2010, 01:11 PM
What happens when you try? Does it just tell you to load ADF? in which case the adf lift sensor is probably stuck so it doesnt recognize you putting an original on the glass. Or are you getting some message or error?
beano
11-11-2010, 01:13 PM
error message im not sure what it is right now i'm on the road away from the copier
mjunkaged
01-19-2011, 09:03 PM
If you don't fully open the feeder to disengage the switch in the rear, it will give you that message, if memory serves me correctly. Is the switch stuck down? It's a plastic arm that protrudes upward rear of the glass.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.