maxtrax
11-23-2010, 06:21 PM
Hi all,
I have a C6501 and it has a problem when i print from the bypass tray, al other trays are always ok.
The problem:
Whene i need 10 prints duplex from the bypass tray and i lay down less then 10 pages on the bypass drawer the machine stops printing whene the last page is fed in and at the last printed page the color yellow is shifted 1 mm (at the duplex side) to the operator side of the machine (Z direction), al other prints are ok. whene i put 10 pages and request a job of 10 pages al pages are ok. So always the color yellow of the duplex side of the last print in a run is shifted and it only happens on the bypass tray al other trays are always ok. I reinstalled the Fiery controller, reinstalled the firmware GMO60, changed the IPB, PRCB video board controller and cable without any result.
Can someone help me?
I have a C6501 and it has a problem when i print from the bypass tray, al other trays are always ok.
The problem:
Whene i need 10 prints duplex from the bypass tray and i lay down less then 10 pages on the bypass drawer the machine stops printing whene the last page is fed in and at the last printed page the color yellow is shifted 1 mm (at the duplex side) to the operator side of the machine (Z direction), al other prints are ok. whene i put 10 pages and request a job of 10 pages al pages are ok. So always the color yellow of the duplex side of the last print in a run is shifted and it only happens on the bypass tray al other trays are always ok. I reinstalled the Fiery controller, reinstalled the firmware GMO60, changed the IPB, PRCB video board controller and cable without any result.
Can someone help me?