PDA

View Full Version : CQ c300 losing yellow image during copying.


Custom Search


copiers4africa
01-07-2011, 12:39 PM
hi everyone i have midboggling problem which i have managed to resolve to some extent.
c300 which irraticly losses its yellow image density completely or a times gradually.

i replaced new yellow image units and replaced toner suplly unit with motors to solve this problem.each time i do the gardations the machine allows the values to change.but when i do the high compression gradations then the machine losess the yello image.

i nvram cleared the machine and toned up the units actdc and toner ratios are appr.9percent...

replaced printer contol board and updated firmware..
tcr sensors are fine and idcs are fine...

copies are almost blue or purple indicating lack of yellow...

i also changed development drive and motors no luck still the same...

finally changed hv unit and no luck...


i am stuck and suffer from a mega headache with this problem....

oh yes i also tried printheads stilll the same...


many thx for your response:confused::confused::confused:

albasoul06
01-08-2011, 03:09 AM
Replace CL3 (# 9322 1300 21) or PRCB

copiers4africa
01-10-2011, 07:15 AM
thnx the prcb has been replaced ..



which clutch are u referring too when u say clucth cl3 (9322 1300 21)

where would this clucth be i.e development drive or...

acusso1234
01-14-2011, 07:36 PM
Take out the belt and look at the roller under the Yellow. Probably it is damaged and don't move during the process. I've changet TBU twice for this in the past.

Custom Search