Minolta Di 620 with pi6200 pro fiery

[mitchl]

I have a bad hardrive in this fiery because when I replaced it with a known good HDD it comes to ready. I then take that hard drive out of that working fiery and try cloning it like I have done with other print controller HDD's using Acronis software and It only shows an unallocated HDD. I usually see the working active partitions. Not in this case.I have even tried other HDD's out of working pi6200 fiery's. Does anyone have any ideas? Thanks.

[Scott_Lewis]

I have tried something similar with poor results. I think you are going to find that the configuration of the drive is password protected and proprietary. See is you can go into the .....can't remember the exact naming...... drive configuration.