View Full Version : Kon 7130 ATS/DV adj
SKTeK315
02-11-2011, 08:14 PM
Hey everybody. Kon 7130. Changed dru, blade & SV. Cleared counts. Set date. No how ti do ATS/ATDC adjustment. Haven't done 1 since the merge. Appreciate the help
albasoul06
02-11-2011, 11:27 PM
8382
SKTeK315
02-12-2011, 12:24 AM
Thanks alot. When I was at the Mach. Today doing the pm, I sort of thought that L is the ATS adj. but wasn't sure. Couldn't find anything that resembled auto toner sensor adj. So I turned it on normally. Yes it coded out. I tried l adj. The right side of screen says 60 or 600 but the left side after start read 0006. Without runing. How do I redo ?
Thanx again
pepper38_cnd
02-12-2011, 01:38 AM
Clean the sensor in the drum cariage and then run L detect again
SKTeK315
02-12-2011, 02:47 AM
I did that as I was changing & vac. Process unit. It's clean. I think there's a sequence of doing it.
humpty dumpty
02-15-2011, 05:45 PM
The sensor on the TCSB is dirty, resulting in improper output to the PRDBie drum sensor... if that is clean your main motor has failed!!! also check your dev unit is rotating!
SKTeK315
02-15-2011, 06:03 PM
Tnx
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.