T81 on second fax

[luis8832]

Working on a bizhub c280. Installed a fax kit and tested ok. Installed a second fax and getting T81 error code. I switched the boards and the same result. Followed the install guide. Did i miss any special settings for the second fax? Any info would be great.

[Mr Spock]

I believe that there is a jumper that needs to be changed and then enter service mode and set the second fax line.

[albasoul06]

1 - The fax target area is set to 'Japan' ????!!!!!!!
2 - Dial Tone Detection is set to ON. ?????!!!!!

W H Y ....?!

[luis8832]

fax target is set to us and i tried turning off dial tone detection same result with the second fax.

[luis8832]

i am now experiencing a new problem, the fax is getting cut off. When sending it it will send like 1 or 2 pages. The line will cut off and wait for a redial. Then it will send the rest. This is a new fax board in the unit. Any suggestions.

[mo0651]

Is the switch on the board been changed to SW1 or SW2 as in setup instructions? and fax initialization go OK?

[luis8832]

yes it did. both initialized properly. When i try to transmit from the second fax it gives the t82 error. also the switches are in proper position, the first one is switch 1 and second one switch 2.