View Full Version : BH 600/750 2nd side folding
SKTeK315
03-13-2011, 05:48 PM
Coming out of duplex, paper buckles a few times between pre-reg & reg rollers putting waves & a fold in the middle. I played with ADU's pre-reg & reg timing. It did change the wave pattern on the paper but still Z-folds middle of sheet.
minimerlin
03-13-2011, 08:03 PM
Clutches? Sensor actuators?
peter lynn
03-14-2011, 09:53 PM
the registration unit whenlifted off the ADU then replaced has a mylar strip on the entry side,is it tucked under the adu plate? ifbuckled it can cause problems in this area..happy copying PETE
Coming out of duplex, paper buckles a few times between pre-reg & reg rollers putting waves & a fold in the middle. I played with ADU's pre-reg & reg timing. It did change the wave pattern on the paper but still Z-folds middle of sheet.
SKTeK315
03-14-2011, 09:58 PM
I'll chck tomorrow but it did it before I swapped the mid section & it worked before delivery.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.