View Full Version : c353 no image
big jase
04-04-2011, 05:53 PM
i have a c353 that comes to ready but showing p codes 5,6,7,8,21 there is no image on paper, all connection look fine , check hv etc any ideas:confused:
Brischaffer
04-04-2011, 06:24 PM
I would maybe try loading new firmware into the machine.
BIG PAPA
04-04-2011, 07:46 PM
First guess would be trans belt. Would explain most p codes, not getting thru stabilization. Does the belt turn? If you stop job halfway is there and image on belt? Or drums for that matter?
boanda
04-05-2011, 08:00 AM
I had same problem. Its PH unit. If u have had some kind of agitation, probably your lasers moved from their places.
Chip Resets SA
04-05-2011, 07:26 PM
I agree! PH unit!
why now new model always PH belt problem ? old model no hv this problem
boanda
04-06-2011, 07:14 AM
well... older machines life time was much shorter, so new problems r some kind of compensation for longer lifetime :(
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.