svwpa
04-09-2011, 05:03 PM
I am installing the printer maintenance kit but cannot pull out the elevator tray to access the filter cover assembly. The manual (p.3-2) gives directions to push down in one place and pull up in another to pull out the elevator tray unit and the horizontal conveyance unit. I have tried but do not want to force the plastic parts. Thanks ofr any ideas on how to do this. Mark
1.2 Replacing the Filter Cover
Assembly & Suction Filter/A
A. Periodically replaced parts/cycle
• Suction filter/A: Every 120,000 copies (7145)
• Suction filter/A: Every 100,000 copies (7235/
7228/7222)
• Filter cover assembly: Every 120,000 copies
(7145)
• Filter cover assembly: Every 100,000 copies
(7235/7228/7222)
B. Procedure
1.
Remove the screw [1], then remove the filter
cover assembly [2].
2.
Remove the suction filter /A [3].
3.
Reinstall the above parts following the removal
steps in reverse.
Note:
• When installing the suction filter/A, be sure to
install it so that the white filter face is turned to the
inside of the main body.
Note:
• When an elevator tray unit is fitted, perform the
following to access the filter section.
• While pressing [1], lift up [2], and pull out the elevator
tray unit and the horizontal conveyance unit.
Do not remove the finisher.
To remove the finisher, see [III. DISASSEMBLY/
ASSEMBLY] of the finisher section
9280
1.2 Replacing the Filter Cover
Assembly & Suction Filter/A
A. Periodically replaced parts/cycle
• Suction filter/A: Every 120,000 copies (7145)
• Suction filter/A: Every 100,000 copies (7235/
7228/7222)
• Filter cover assembly: Every 120,000 copies
(7145)
• Filter cover assembly: Every 100,000 copies
(7235/7228/7222)
B. Procedure
1.
Remove the screw [1], then remove the filter
cover assembly [2].
2.
Remove the suction filter /A [3].
3.
Reinstall the above parts following the removal
steps in reverse.
Note:
• When installing the suction filter/A, be sure to
install it so that the white filter face is turned to the
inside of the main body.
Note:
• When an elevator tray unit is fitted, perform the
following to access the filter section.
• While pressing [1], lift up [2], and pull out the elevator
tray unit and the horizontal conveyance unit.
Do not remove the finisher.
To remove the finisher, see [III. DISASSEMBLY/
ASSEMBLY] of the finisher section
9280