View Full Version : bizhubpro c6501
Hi,
have bizhub c 6501 warms up o.k. but from there does not come ready keeps on displaying stabilizing. new imaging units & transfer belt.any guess what could be the problem with the machine.doesnt display any error code.
thanks
CT Copier Repair
04-24-2011, 08:55 PM
Firmware
or setup problem ie when new image units and or developer were replaced they were not set up correctly
but i'd try firmware first
Firmware
or setup problem ie when new image units and or developer were replaced they were not set up correctly
but i'd try firmware first
machine was working working o.k after replacing the parts .problem is keeps on running (stabilizing ) forever.any failure in related parts like transfer belt or pgc sensors.
engineer
06-21-2011, 04:06 PM
is in display still "warming up"?
1FRY1
06-21-2011, 11:50 PM
If it says "warmimg up" all the time then one of the three upper heater lamps has gone
check each one
Hi all
thanks for you suggestions.problem was neither firmware or fuser unit related.
it was a malfunction of a pulse sensor
thanks
Jsh77
08-19-2011, 05:28 PM
Try to change:
65AA 5365 1 FIXING LIMITTER
A03U 7256 00 Fixing Regulating Shaft /A
I had a similar problem, machine was in warming up mode for a long time. Limitter was slipping...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.