View Full Version : Konica Minolta 8050- SC41-02 error code. Any suggestions?
JSelman
05-11-2011, 02:00 PM
I just got a call about this and have no idea where to start.
Anyone have a service manual or know what the error means?
Any help would be appreciated.
:cool:
Luther
05-11-2011, 02:13 PM
yellow polygon motor failure
JSelman
05-11-2011, 02:21 PM
Thanks for the reply Luther,
From what I can put together it sounds like 41 error is a failed write/laser unit or suction/exhaust fan.
the second part, 02, indicates the color.
"yellow polygon motor failure"
Is the motor inside the laser unit or is it a single part that can be replaced?
Luther
05-11-2011, 05:17 PM
it comes as a unit...i dont know if you can lube the shaft on the motor you can try it
Luther
05-11-2011, 05:20 PM
and i think 42 codes are fan codes, 41 codes are write unit codes and the sub code tells you the color, its either a failed write unit or the printer control board...good luck
JustManuals
05-11-2011, 07:31 PM
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads (http://www.justmanuals.com)
Paul@justmanuals.com
empiru
05-13-2011, 10:36 PM
Hi!
I had the same problem with a Bizhub Pro C500 - almost the same machine and I only cleaned very vell the exhausting fans from the writing units and all the path of the air from around them. I did this about 3 weeks ago and the machine still works fine, no problems...
henry finley
05-12-2014, 11:09 PM
Bringing up an old thread with a question. It's May12 and it's back to some serious heat in my non-air conditioned house. Coult this error just be a normal condition from a C-500 idling several hours? I turned off the machine for 15 minutes and when I turned it back on the error was gone. Thank you.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.