emujo
05-19-2011, 09:15 PM
C353 at latest firmware, approx 150K around 80% B&W... I can't seem to get the front to rear registration adjusted to specs. With the trays (LT and LG) centered, the front to back reg is off by at least 1 inch. All the way foward gets close, but customer prints close to the edge and info is being blanked on 1 side. Manual tray has same issue. I played around with setings in SM but no change. Any thoughts on how to bring this excessive shifting under control? PS several techs have addressed this issue w/ customer in past, so I have no clue as to what was done to get it messed up in the 1st place. No skew, image is slightly reduced lead to trail (about 2%) and 1-->1 front to rear. Thinking about a Data clear, but don't want to deal with re-doing all settings. TIA Emujo