View Full Version : Error code J32-02
Maindron1
05-29-2011, 05:30 PM
I need help with a J32-02 from a Konica 7155. I have done everything and it still doing it. Any inout will be greatly appreciated.
Thank you.
minimerlin
05-29-2011, 09:40 PM
What exactly have you done to try to clear it? Are you a tech? Do you have the manuals and have you followed the troubleshooter? Have you used the search on this forum for this code?
Maindron1
05-29-2011, 09:47 PM
I switched the fusing unit with a working one, I changed the ADU board. One thing I notice is that the solenoid switch that opens up the exit gate does not come on, the paper stops while going down the duplex and that is why I thought that the ADU board was faulty. Yes I have the 2009 updated manual for this machine and I have followed the troubleshooting steps and it is still doing it.
minimerlin
05-29-2011, 10:10 PM
Does the fault happen when doing copies from the glass and via the Doc feeder? What about the internal test prints.
Maindron1
05-29-2011, 10:22 PM
It does it for everything even face up copies.
minimerlin
05-30-2011, 08:50 PM
It does it for everything even face up copies.
A face up copy does not go into the turn around area so you need to find out why it is! Is the return spring fitted to the guide?
JustManuals
05-30-2011, 11:23 PM
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads (http://www.justmanuals.com)
Paul@justmanuals.com
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.