View Full Version : 7135 F35-1 Release latch?
mrfuser
06-10-2011, 05:38 PM
Okay, rebuilt fuser due to many error codes on fuser. We still get an F35-1 and we go into 25 mode and clear it, but it comes back. Manual says we must "release latch" or it will return. What does "release latch" mean? Open and close front door or something?
Thanks all
Kelly
SmellsHot
06-10-2011, 05:46 PM
25 mode, DIPSW settings, bit 3-1 change to OFF
Did you replace temp sensor and/or thermostat?
mrfuser
06-10-2011, 06:00 PM
I clear the code, but the book says if we don't "release the latch" the code will come back. What is the "latch" it is referring to?
Kelly
SmellsHot
06-10-2011, 06:02 PM
Clear it by resetting it in DIPSW's? (this is the latch they are referring to)
Did you replace sensors?
mrfuser
06-10-2011, 06:14 PM
No, they meter out fine, should we replace anyway?
Kelly
SmellsHot
06-10-2011, 06:18 PM
absolutely! Thats why your getting errors. If you can replace the temp sensors and stat, if your being cheap start with sensors and cleaned stat head
CraigW
06-10-2011, 06:29 PM
White thermistor leads = BAD
Yellow thermistor leads = GOOD
mrfuser
06-10-2011, 06:33 PM
Good to know on the leads. I had a set from a 7145 I can throw in there.
Thanks guys!
Kelly
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.