PDA

View Full Version : Having problem interpreting a solution for an error code


Custom Search


Maindron1
06-30-2011, 05:34 PM
Abnormal noise and/or jam codes J11-xx, J12-xx, J13-xx, J14-xx, J15-xx.

Solution

CAUSE:Cap of the torque limiter misaligns and torque on the separation roller (p/n 55VA R749 00) increases.
Note : Jam codes associated with trays:
Tray 1: J11-01, J11-02, J11-03
Tray 2: J12-01, J12-02, J12-03
Tray 3: J13-01, J13-02, J13-03
Tray 4: J14-01, J14-02, J14-03
Tray 5: J15-01, J15-02, J15-03

SOLUTION: Replace the torque limiter and separation roller (if needed).Design of torque limiter has been changed. Modifiedstyle torque limiter (p/n55FA 5819
1E).

My question is where is the "Torque limiter" located?

Please help.

habik
06-30-2011, 05:47 PM
10588

Its next to separation roller. on every cassette or tray. (Inside machine)

lemme take a picture :)

The Blue (or orange or green) bit is your rubber roller and the spring is resistant/ friction torque limiter.

What machine have you got.?:cool:

Luther
06-30-2011, 05:48 PM
is this a 70 or 71 series machine? if it is there are 3 feed rollers 1 is grooved, the other 2 are not and they come in contact with each other the torque limiter is attached to the lower roller, the entire separator assembly comes out with on screw from the duplex door side,it will show you in the parts manual feed assemblies are basically the same in all konica machines and in fact most machines use a torque limiter i would say if you dont know where it is located you may be in over your head

habik
06-30-2011, 06:09 PM
is this a 70 or 71 series machine? if it is there are 3 feed rollers 1 is grooved, the other 2 are not and they come in contact with each other the torque limiter is attached to the lower roller, the entire separator assembly comes out with on screw from the duplex door side,it will show you in the parts manual feed assemblies are basically the same in all konica machines and in fact most machines use a torque limiter i would say if you dont know where it is located you may be in over your head

Great expression Luther :D

Custom Search