PDA

View Full Version : Error Code C-2434 bizhub c6500


Custom Search


jzheld
07-21-2011, 04:33 PM
C-2434 On initial adjustment of the TCR
sensor/K, when the control voltage
was minimal, TCRS/K
detected over specified value.
Printer control board (PRCB)
Developing motor/K (M23)
TCR sensor/K (TCRS/K)

don't know where to start, is that just not enough developer? I changed TCR sensor, changed corona as well, still the same, any suggestions?

ineo+6501
07-21-2011, 04:42 PM
Change the Black developer

jzheld
07-21-2011, 04:47 PM
Change the Black developer

Thanks will do it now

empiru
07-21-2011, 05:18 PM
Exactly, you have to change the developer; I just wanted to tell you that I had the same code and after I changed the Black Developer, the other colors started popping out SC- codes for the TCR sensors... and I had no choice but to replace all the developers.

jzheld
07-21-2011, 05:36 PM
Exactly, you have to change the developer; I just wanted to tell you that I had the same code and after I changed the Black Developer, the other colors started popping out SC- codes for the TCR sensors... and I had no choice but to replace all the developers.

did you replace just the developer? not developer tank?

JustManuals
07-21-2011, 07:46 PM
This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)

Paul@justmanuals.com

jzheld
07-21-2011, 08:20 PM
Thanks for the help, I changed all the developers (needed to do soner or later) work perfect now

Custom Search