PDA

View Full Version : konica bh c353 ICP fuse blown


Custom Search


acsolutions
07-25-2011, 08:39 PM
Hello,
I have an ICP fuse blown on my controller board (ICP5) does anyone know what it is rated at? I was told I could solder a new one in. I have a 1/8 amp and a 1 amp fuse (inline) will one of these work? I have never done this before so I was going solder a new one in Parallel.

jimmyjwc
07-27-2011, 03:28 PM
ICP5 on the C353 is 2.5A. Did it blow when resetting the fuser or transfer belt?

acsolutions
07-27-2011, 04:44 PM
No it did not blow I checked it, there was cont. using 80ma fuse to reset transfer belt.

Custom Search