PDA

View Full Version : Konica IP511A system code


Custom Search


mascan42
07-27-2011, 02:25 AM
I have a customer that keeps getting SC4901 and 4904 codes on their 7255, and the problem seems to be corrupted system code on the controller. Problem is, I can't locate a service manual for an IP511A, so I don't know the procedure for reimaging the controller HDD. Any ideas?

Woxner
07-27-2011, 02:29 AM
Been awhile on this but if I remember it's through a parallel port. I will send you the manual email me woxner@copytronics.net

ddude
07-27-2011, 05:42 AM
Trying to install firmware via KMBS method is tough on this box-

pepper38_cnd
07-27-2011, 11:35 AM
Connect via the serial port using TeraTerminal while you see the Memory check type "KA" (without quotations) this will boot it to a DOS Prompt change Derectories and type "Restore" this will load the previous backed up version of the system code. Usually works as long as the HDD is not bad.

Custom Search