PDA

View Full Version : Jamming BizHub Pro 1050 EP Paper feed problem - J18-07


Custom Search


scotsman60
08-23-2011, 02:15 AM
Hello!!!!

I'm having a problem with my BizHub PRo 1050 EP.

When I feed from drawer 4 in the PF, I get a J18-07 jam code.

From the manual - this code says - "The PF exit sensor (PS99) does not turn ON within a specified period of time after the loop sensor /2 (PS94) turns ON."

So I replaced the Exit sensor - no change

If I pre-feed a sheet partially through the feed rollers, this sheet feeds fine but the jam code comes up on the second sheet.

I relaced all of the paper feed rollers - didn't make any difference.

I'm thinking one of the PF clutches may be slipping, or maybe the rollers in the vetrical conveyance section might need replaced?

Any ideas on what I could try first or how I should diagnose this?

Or is there something else I should be looking at?



Thanx in advance,


Doug

Custom Search