PDA

View Full Version : ineo/Bizhub C/+ 450 calibration..


Custom Search


inutelkamo
09-05-2011, 12:29 PM
Good day..

Any one encounter this type of problem in C450...

Im about to calibrate the unit..
1st, i must print a calibration pattern to be scanned on flaten glass, i use A3 size..
and okey, it prints..

BUT, when i put it on flatten glass and scan the pattern this error comes out;

"scanner error"
or somthimes
"stabilization NG"

any one encounter this? or suggestions?

Thx in advance..

kingarthur
09-05-2011, 12:55 PM
go to page 296 ( chapter 10.4.6) on the Version 3 aug 2006 service manual & adjust the scan area....i had the same problem on a C352

inutelkamo
09-05-2011, 01:46 PM
go to page 296 ( chapter 10.4.6) on the Version 3 aug 2006 service manual & adjust the scan area....i had the same problem on a C352

aw... didnt notice that....
but when photocopy function is used, its all okey!
is it same with you still?

kingarthur
09-05-2011, 04:54 PM
hi...its ok..i did the same as you & posted it on this forum, thats how i got the answer. When you scan & copy its fine...it's only when you or the customer carries out the gradation. good luck

JustManuals
09-05-2011, 07:19 PM
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

Custom Search