c351

[wcody76]

hey guys i have c351 that i changed the print controller now i get a error code cfe03 i tried formatting the hard drive i put the original nvram back on the board but when i scan it hangs up and gives the error code

[Bernard]

Did you put the eprom from the old board to the new board? Also update the firmware

[wcody76]

yes to the eprom no the firmware unable to find a good card keep getting a bad cf card error and im formatting n putting firmware on with the imaging tool

[Bernard]

I was able to finally shoot it with USB card brand "DataStick Pro" 1 gigabit by Centon. I don't know why they are so touchy regarding the flash cards.

[SKTeK315]

Yo. Wassap !!!I'll call Nelson. Just before u came to benchmark.

[Ianizer]

That's an MFP board error.
I'd say go back and make sure you plugged everything in.
-I

[SKTeK315]

That's an MFP board error.
I'd say go back and make sure you plugged everything in.
-I

U got the cards from the sourse. He uses them. I'm sure he gave u a few pointers.
There is a procedure how to do it. From before u turn off the Mach. & u have to turn off the Mach. Through removal, of card.
I think the sequence was wrong. Try again.