Goodday guys, I have another issue with Konica 7033 and I need your help. It is displaying error code F 35-4. Thanks
Error code for Konoica 7033
Collapse
X
-
-
Re: Error code for Konoica 7033
It's a fuser code. I would replace the thermistor (fixing sensor) PN: 26NA 8801 3
Then go in 25 mode software switch 3 - 1 set to 0 to reset the error. If you just go in and reset it with out replacement of sensor, it could cause problems or work flawlessly. Its your choice.Comment
-
Re: Error code for Konoica 7033
Yes, try to reset the error before replacing anything - 9 out of 10 times* the machine works fine just by resetting it.
* Tested in independent laboratories in Rafakistan. Your milleage may vary.' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!Comment
Comment