[Error Code] C1101 on KM bizhub 600 with FS-601

[ricmartinho]

Hello,

I have a KM bizhub 600 with FS-601 that keeps throwing C1101 when I turn on the machine and close the conveyance door of the finisher.
It started after I took the finisher out (the wrong way!) I lowered the tray by removing the metal plates of the timing belt to unscrew the stepped screws when it was just the screw at the bottom of the sorter (dumbass!)

Anyway, when it was all put together and connected to the machine, the C1101 started. If I power on the machine with all doors closed the error pops up immediatly. If I power with the finisher top door open, the error pops as soon as I close it. The tray motor works when I open and close the top door and I tested the shift motor with an external power source and it works.

Any ideas?

Thanks

[mrwho]

Re: C1101 on KM bizhub 600 with FS-601

I was just looking at the KM ICP listing and had an idea:

Check the ICP11 on the finisher control board (according to this listing, it controls both the M2 and M8 motors)