Desert Rat
12-15-2011, 03:19 PM
Earlier this week I installed the 200K PM kit. All the parts 'cept the grids went into the machine.
It ran for most of yesterday after my second trip. I found that the bumps on the stop thing
were not against the plate. I paid close attention and noticed that as the screw
was tightened it would move away. I corrected this and made sure the belt was installed
correctly. Put the tracking adjustment back to where it was originally marked. Ran the
color registration and auto gamma. Watched the customer run a couple of hundred
prints, no problem.
Then they called back this morning.
Is there something else I need to do or un-do?
I checked all the rollers and they are in the holders correctly.
I cleaned the transfer assembly before installing the parts.
The ring on the transfer rollers are toward the back of the
transfer assembly.
It makes a nice copy off the glass. They only thing I noticed off the glass
is a small bullseye target that looks like a cut mark. It is black, process black.
I can see a slight magenta hue in the very center. I have cleaned the optics.
As long as the belt stays in place it makes a good copy.
They have stopped using after market toner, but I did not get the chance
to clean it all out. They just put it in and let it run itself out. I told them
to run the toner refresh.
Thanks for any help
DR
It ran for most of yesterday after my second trip. I found that the bumps on the stop thing
were not against the plate. I paid close attention and noticed that as the screw
was tightened it would move away. I corrected this and made sure the belt was installed
correctly. Put the tracking adjustment back to where it was originally marked. Ran the
color registration and auto gamma. Watched the customer run a couple of hundred
prints, no problem.
Then they called back this morning.
Is there something else I need to do or un-do?
I checked all the rollers and they are in the holders correctly.
I cleaned the transfer assembly before installing the parts.
The ring on the transfer rollers are toward the back of the
transfer assembly.
It makes a nice copy off the glass. They only thing I noticed off the glass
is a small bullseye target that looks like a cut mark. It is black, process black.
I can see a slight magenta hue in the very center. I have cleaned the optics.
As long as the belt stays in place it makes a good copy.
They have stopped using after market toner, but I did not get the chance
to clean it all out. They just put it in and let it run itself out. I told them
to run the toner refresh.
Thanks for any help
DR