PDA

View Full Version : Konica 7020


Custom Search


ATSBMCO
10-30-2007, 12:41 PM
We have a customer with this model and the fault is that it will not drive any of the paper feed system, cassettes or manual by-pass.

I have checked the gearing system and the only problem I could see was that there is a solenoid that transfers the drive, it is this that has no function, all gears are fine.

I measured the power to this solenoid and it has none. Does the machine require a reset or does any body out there have any further checks I should do?

random
10-31-2007, 06:14 AM
A fuse is blown on the driver board. You should either test all the drives in I/O mode or swap the driver board (sits above LVPS)

Juggy
10-31-2007, 02:16 PM
The driver board has almost around 12- 13 ICP which is like fuses, you need to check for the one which is open and repair it with a fuse which is less than 600ma in some cases or 1 -2 amps in some cases.

ATSBMCO
11-02-2007, 11:17 AM
Thank you,

You fellas where correct!

Replaced the faulty ICP and the customer is now back up and running.

GottaFixEmAll
11-10-2007, 11:05 PM
That happened to me as well, funny, the problems that never come up in the training school ... Real Life !!!

Custom Search