PDA

View Full Version : Jamming FS 503 finisher problems


Custom Search


copycorner
02-07-2012, 06:07 PM
When I plug in the FS 503 finisher to the saddle stitcher the only way the finisher is recognized is when I leave the front door interlock open until after the copier boots up . Then if I close the interlock the bizhub 1050e will allow the stapler function to display. When I send a document to be stapled the paper just keeps piling up before it goes to the stapler and eventually jams the copier up. When I clear the jam and try to reset the finisher by opening and closing the interlock of the front door it does not reset and displays that the finisher is now operating when it is not. Any suggestions would be appreciated.

Custom Search